HNT Gordon Block Plane

HNT Gordon Block PlaneThis block plane has a higher blade pitch of 55 degrees optimized for hard, difficult timber. However, it works equally as well on softer woods. Used for general purpose planing or trimming of any small pieces of wood, particularly hardwood and end grain. Easily used in one hand. It is 6 7 8 long x 2 1 8 wide x 1 1 2 high. Weighs 1. 75 lbs. Option of an O1 Tool Steel (O1 TS) blade hardened to RC 62 64 OR High Speed Steel (HSS) blade hardened to RC 62.

023" fret slots in a single pass

one hour away from Lisbon

they can't rust

The size range of the diamond abrasive used in this plate is 45µm to 54µm (270/325 mesh)

We also recommend that you flatten the back once before the first honing

Replacement White Nylon Face ref  76-712NF

Hamilton Toolworks have been handcrafting beautiful ergonomic marking gauges in Arkansas USA since 2005

This set of roller guides made by Benchcrafted for Leg Vises is new and unused

it is by far the best lapping plate that we know of

Screwdriver blades are constructed of Chromium-Vanadium steel alloy

You can put a cork rubber liner/ leather (or equivalent) soft jaw on the front and/or back jaw  for better work holding when dealing with timber that is not quite parallel

Blade width: 30 mm