BMW E9X Vent-Mounted GFB-3 Case (2006 - 2011 BMW 3-Series)

BMW E9X Vent-Mounted GFB-3 Case (2006 - 2011 BMW 3-Series)Mount your Go Fast Bits G Force III boost controller directly to where your OEM defroster vent is without having to drill any holes in your dashboard or your A pillar! These mounts were created by using a 3D scan of the original dashboard defroster vent, then modeled to accept Go Fat Bits G Force III controllers. Our pods and mounts are 3D printed using a high quality Nylon like resin, which is then sanded and painted to provide a near OEM look.

Wash or blow off the excess dust and allow the Navpod to dry

1' F20   (07/2010 — 02/2015)

Once we receive your order

Using trim removal tools is recommended

We recommend using the HW05 and below module

6x 4" Zip Ties

Once the epoxy cures

A: Check out this helpful guide from Skrillah416 on the Spool Street Forums: https://www

Q: This is 3D Printed

Gauge is not included

Please note that the raw finishes will have some rough surfaces on due to the support material required when printing these

The heatsinks provide minimal additional heat dissipation and the kit will work without them